Settings Class |
Namespace: com.gigatms.Parameters.CES
The Settings type exposes the following members.
Name | Description | |
---|---|---|
![]() | EventType |
Output raw data or decoded data when inventory tag.
|
![]() | InventoryActiveMode |
Gets the inventory mode.
|
![]() | Profile |
Gets the Global frequency regulations for RFID profile. This property is read-only.
|
![]() | RfPower |
Gets the RF Power strength. The value is ranging from 1 to 27. The default value is 11.
|
![]() | TagPresentedRepeatInterval | Time interval between reader raise a OnTagPresented or OnTagPresentedEx event. This setting control how often to notify that a tag is presented, not how often the reader inventory. Valid values are 1 to 253 (0.1s ~ 25.3s), 0 (immediately) and 254 (Never repeat). Default value is 254. Immediately means reader will raise tag presented event after each inventory round as soon as possible. Never repeat means tag presented event will raise only once until the tag is considered removed and show up again. ![]() |
![]() | TagRemovedThreshold | How many times (offset by 1) of failed inventory round before the tag is considered removed and then raise tag removal event. If Tag Remove Threshold is set to 2, reader will output a tag removal event when an inventoried tag failed to inventory [2-1=1] time. Valid values are 2 ~ 254 (1 time ~ 253 time), [0 or 1] (immediately). Default value is 5. Immediately means reader will raise tag removal event and tag presented event at the same time because [1-1=0] and [0-1=-1]. This setting is used to reduce the false tag removal events. ![]() |